(as of Apr 20,2021 11:41:02 UTC – Details)
An easy One-Step Wire Connections.
Comply with all Relevant European Standards.
Polyolefin heat shrink butt connectors improve Pullout Strength.
Easy Identification: Different Colors for Different Sizes of the Connectors.
High-quality wire connectors in Seal, Strain Relief, Cable Check and Insulation.
Ideal used in Marine, Automobile, Motorcycle and other Outdoor Applications.
Melted Solder ensures wires Strongly Connected and avoids wires slipping out from the terminal.
Material: Preformed Solder Rings
Color: Yellow, Blue, Red, White.
10 x Yellow Connectors: Diameter 6.0 mm, Cable cross-section 4.0-6.0 mm²
30 x Blue Connectors: Diameter 4.5 mm, Cable cross-section 1.5-2.5 mm²
35 x Red Connectors: Diameter 2.7 mm, Cable cross-section 0.5-1.0 mm²
25 x White Connectors: Diameter 1.7 mm, Cable cross-section 0.25-0.34 mm²(A.W.G.:26-24).
1 x 100pcs (Four Sizes / Colors) Solder Seal Connectors
1 x Reusable Case
No Crimping Required – Much More Convenient Than The Old Way
You have to use pliers and heat gun to finish the wire connect project when using the old style butt connectors, in this kinds of connector, you use use heat gun then you can finish your project. It is much more convenient than the old way. Besides, you can also use them in hard to reach or limited space environments easily.
Upgrade Overheat Resistant Material of The Shrink Wrap Tube
It is hard for beginners to control the heat shrink temperature when first to try these heat shrink wire connectors. Sometime, exorbitant temperature make the wrap tube melt but the solder ring still not melt, which result in failing to connect the wire. So, CACHOR upgrade and use special material in the transparent tube, which can prevent the tube melt when it increase to a high temperature in a short time.
Thread the connector to one of the wires like the picture above.
Put the two end of wire which was stripped off together and twist them.
Move the connector to the middle of the two wire, align the tin ring to the uncovered wire.
Apply heat to the tin ring, please rotate the wire when applying heat until to the ring melt. Then apply heat to the two hot melt waterproof adhesive until it shrinks to fit the wire closely.
Waterproof and Insulation: polyolefin tubing in outside and hot melt rings in inside effectively improve waterproof performance
No Slip Wire Contact : Tubing reduces in size and solder will melt and flow through the stripped wires, ensure strong holding — your wire will never slip out of the connector.
Application areas: application in areas such as automotive, watercraft, electrical and electronics industries, 4 different sizes, So that repair work easier.
High Quality: Provide warranty & friendly customer service ,We have a commitment to every buyer 100% satisfaction